AC Terminals, Inc.

Heavy Duty Welding Cables Part Number: WCB - Welding Cable Black. Part Number: WCR - Welding Cable Red. Part Number: JC - Jumper Cable. Use suffix to indicate desired length. Example: 8002WCB-25 for 25' length.

Can be crimped or soldered. Pure 131 contact copper (93-95% copper) & bright tin plating, exceeds SAE conductivity standard J163. Electro-tin plating for complete coverage, better appearance, high conductivity and corrosion resistance. Connectors can be installed with adjustable crimping tools and are solderable. Can be color coded. Use prefix C to have parts color coded (Example: C2101T). Dual crimp identifies and matches cable size. Raised lettering for easy identification of polarity, wire size and crimping codes. The 2112TAO terminals have accessory wire capability. Note: 1-2 gauge can be used for either 1 or 2 gauge.

These 4GA and 20 battery terminals can be installed on 20 battery cable without crimping tools or solder (cannot be used with welding cable). Terminals are cast with 131 contact copper (93-95% copper) to ensure malleability and high conductivit.y Exceeds SAE conductivity standard J163. Electro-tin plating for complete coverage, better appearance, high conductivity and corrosion resistance. Raised lettering for easy identification of polarity and wire size. Extra deep chamfer helps wire installation. The inside of the barrel is threaded with two distinct stages of threads. The thread grabs the bare wire, and when tightened it gives an incredible pullout strength. Installation is done using only a screw driver and vice. Installation is completed quickly and easily.

Translucent, adhesive-lined polyolefin tubing allows visual inspection, prevents wire corrosion, and provides a waterproof seal. Conforms to automotive manufacturers' specifications for wiring repairs, necessary for maintaining electrical warranties. Seamless butt connectors & brazed seam rings and spades prevent opening of connector barrel. Color-coded tubing with wire gauge imprint provides easy identification of the correct part for the job

Withstands severe mechanical requirements of U.R.D., submersible, and direct burial installations. High impact, abrasion, corrosion, and chemical resistance. Rated for 600V, 90°C continuous use. Thermoplastic Adhesive Liner provides complete environmental protection and insulation. Meets: UL 486D, CSA C22.2 No. 198.2, ANSI C119-1, Western Underground Guide Numbers 2.4, 2.5, ECEA and NEMA insulation thickness requirements. Continuous operating temperature: -55°C to 110°C. Shrink temperature: 120°C.

Strip the proper size cable so the exposed cable will reach the top of the battery terminal. The cable installation should fit snugly against the top. Insert proper size solder pellet and apply solder flux. Secure the battery terminal in a vise. Slide the proper size heat shrink tubing over the cable. Insert the exposed cable into the terminal. Heat the base of the battery terminal while applying gentle downward pressure on the cable. As the solder melts, allow the cable to slide into the terminal until the installation is snug against the top of the terminal. Remove from heat. Slide the heat shrink tubing over the connection. Apply indirect heat to the tubing. Allow connection to cool. You now have “The Perfect Connection”.