Advance Lifts, Inc.

Full 135 degree tilt. Machine grade double acting cylinders with spherical rod ends. Continuous duty motors Controllers are Underwriter Laboratory approved assemblies. All bearings are lifetime lubricated.

• Model NumberTT-230-8

4 All of the controllers are Underwriter Laboratory listed assemblies. 4 The cylinders on 45 and 60 degree tilters are double acting machine grade. 4 All units are fully primed and finished with a baked enamel finish. 4 All pressure hoses are double wire braid with JIC fittings. 4 All reservoirs are mild steel. 4 These units conform to all applicable ANSI codes.

• ModelPAC-200
• Capacity200
• Overall (in.) Height80 + Travel
• Size (in.) Max36 x 36

Used to raise, lower, position and transport loads. Casters and push handle for easy maneuverability. Rear casters lock to keep the unit stationary while working. Large and easy to use lifting and lowering mechanisms built into the unit.

• Series1000 Series

All models are equipped with a hinged bridge equipped with a pull back chain. All models have an approach ramp, wheel chock. All of the electrical controllers are Underwriters Laboratories approved assemblies. Each unit is washed with phosphoric acid, fully primed and then finished with baked enamel. All cylinders are machine grade with clear plastic return lines. All pressure hoses are double wire braid with JIC fittings. Reservoirs are mild steel. These units conform to all applicable ANSI codes

Non-Powered turntable features: Lower cost than powered turntables These units are manually rotated. These units can be rotated in either direction All non-powered turntables are low profile. Standard platforms are rectangular and round platforms are optional on all models except TML. Rotational limits can be provided via optional detents, locking pins, and hard stops. TM platforms are supported by lifetime lubricated roller bearing cam followers. TML platforms are supported by lifetime lubricated ball bearing roller. Platforms rotate around a lifetime-lubricated kingpin bearing. Powered turntable features: Used where more frequent turning is required. Used where rotational effort would be too high in a non-powered turntable. Standard turntables use DC motors and drives; AC motors and drives are optional Standard rotation is clockwise only. Standard platforms are rectangular and round platforms are optional on all models except TML. Optional bi-directional rotation (clockwise & counterclockwise) requires an AC motor and drive. Platforms rotate on a lifetime-lubricated kingpin bearing. Platform travel can be limited by use of optional limit switch (+- 3º accuracy). Powered turntables are available in low profile and high profile configurations. Low profile powered turntables: – Use for powered applications where low platform height is important. – Circular platforms are required, rectangular platforms are not available. – Drive motor is located at the edge of the platform and projects above platform. – Platforms are supported by lifetime lubricated roller bearing cam followers. High profile powered turntables: – Use for powered applications where low platform height is not important. – Standard platforms are rectangular and round platforms are optional. – Drive motor is located under the platform. – Platforms are supported by inverted casters with tapered roller bearings or cam followers