Manufacturer / Exporter / Supplier Of A54812-SW SAS switch, APC2-MID-01 mid-bus probe, APC3-MID-01 mid-bus probe, DataBolt SAS switch, Signal Quality Tester, UHS-II Test Fixture Set, High Speed Interconnect Tester, A34012-PCI pci extender card, A51606-SW sas switch, Interconnect Tester Read More
The A9-UHS2 Test Fixtures enable designers to verify compliance UHS-II host systems and UHS-II card components to the SD Card Association UHS-II PHY Test Specification. The test fixtures provide an SMA interface between UHS-II components and analysis equipment. Transmitter and receiver compliance testing and return loss measurements of UHS-II systems can be achieved using the A9-UHS2 test fixtures. Features: Compliance testing of UHS-II with bus speeds up to 1.56Gbs. SMA connections for access to D0, D1, and RCLK differential signals. Test point access to legacy SD card signals. Measurement of power consumption of 1.8V and 3.3V on UHS-II cards. Determine power delivery capability of 1.8V and 3.3V on UHS-II host systems. s-parameter file for de-embedding the effects of the test fixture. Each test fixture set comes with the following items: A9-UHS2-01 Host Test Fixture A9-UHS2-03 Device Test Fixture Typical s-parameter file for each fixture type Through board for use in calibration Four phase-matched SMA cables User Manual Hard wood carrying case
Astek Corporation's Interconnect Tester (QP-ICT) provides the ability to test one (1) to five (5) interconnects simultaneously. An interconnect could be a cable, cable with slip-ring, or a series of devices that include a 1394 PHY. Each QP-ICT connection provides outputs with amplitude control. Each output is individually calibrated and controlled for maximum configurability. Each port transmits packets to the IEEE-1394b bus and receives data from the IEEE-1394b bus. Each packet is verified by the receiver of the packet. Two models of QP-ICT are available: the QP-ICT-4 supports S100, S200, and S400 testing and the QP-ICT-8 supports S400 and S800 testing. The default configuration for the QP-ICT is capacitive coupled. Astek's Interconnect Tester (QP-ICT) is built upon a scalable platform with the VersaPHYTM Backchannel and is targeted at IEEE-1394b testing. Engineered to conveniently test up to 5 cables simultaneously, the SQT automates all testing and generates a summary report at the conclusion of each test. The QP-ICT Test System requires Windows 7.
Share your thoughts with other customers for Astek Corp
Add Review
