Belden, Inc.

United States

• Size3/8
• Part NumberUJ-HD375

The Belden single pin & block universal joint is manufactured from high-grade alloy steel for increased durability and better performance than standard industrial-grade models. All components are heat-treated, precision machined and ground to close tolerances. The Heavy Duty, High Strength or Leveler Strength universal joint provides exceptional service life in the most demanding applications. All joints are available with or without a lubricant retaining boot.

• Size5/8
• Part NumberDUJ625

The Belden double universal joint provides the same reliability and service life as the single universal joint with a maximum combined working angle of 70°. Double universal joints provide accurate positioning and flexibility under higher operating angles. Belden double universal joints are available in a wide variety of materials and finishes. Lubricant retaining boots are recommended for operation in corrosive environments.

• Size3/4
• Part NumberUJ-NB750

The needle-bearing universal joint is fitted with pre-lubricated needle bearings. Needle-bearing universal joints are designed to maintain low backlash for critical positioning applications required by robotics and instrumentation and are excellent for continuous operation applications. The joint has rigid axial stiffness for pushpull loads and can handle higher angles and RPM.

• Size3/8
• Part NumberMS2027086

Belden’s complete universal joint line includes a full range of military certified and continually tested universal joints used in defense vehicles, as well as shiftgear change linkage in specialty vehicles.

• Part NumberUJ-HD10
• D210

The Belden pin and block metric standard universal joint is manufactured from quality, high-grade alloy steel. The metric single universal joint can operate at angles up to 45° and metric double universal joints can operate at combined angles up to 90°.

• Size1/2
• Part NumberUJ-SS500

The standard stainless steel joint is made from AISI 303 and AISI 416 stainless steel. The joint yokes are 303 and the pins & blocks are hardened 416 stainless steel to provide higher strength and improved wear resistance. Yokes can be made from 303, 304, 316L, 416 and 420 stainless steel to meet the customer’s exact application specifications. For additional environmental protection, pins & blocks can be covered by lubricant retaining boots or manufactured from higher grades of stainless steel.