Cleveland Steel

JUO Offset hangers are made with either the right or left flange formed inward. This style attaches at the end of a header or in tight areas. JUP Pitched hangers are made with the seat either sloped up or down. JUR Reverse hangers conceal the flanges or permit attachment at either end of the header. They are made for 3" and wider. JUS Skewed hangers are made with the pocket either angled toward the right or the left. This allows for angled members to be supported. JUSP Skewed and Pitched hangers incorporate both the skewed and pitched

BH Bucket Hangers bolt to 2x8 min. webs. BHR Radial Hangers for multiple members. BHS Hangers are skewed 45°, specify right or left hand. BHJ Hangers carry 2 ply hip truss and end jack. BHT Terminal Hangers accept 45° hips, one or two ply, plus single ply end jack. Bolting plate is 14 x 7 x 27 high. MATERIAL: BH, BHS & BHJ all 14" A-36 steel. BHT pockets are 316" A-36 steel. FINISH: Black copolymer finish. CAUTION - 2 x 8 maximum bottom chord on carrying girder. Skewed version requires special location of web. WARNING - all girder plys must be securely fastened together to act as one unit and the hanger bolts are not to be considered for this purpose.

Compression Bridging installs very quickly after sub-flooring is in place. No nails required, only a hammer needed. Reduces labor cost by 75%. Steel formed into a rigid channel shape. Single sharp barb pen- etrates readily at top, two ears bear cross-grain to limit penetration. Dogleg drives into joist to anchor lower end. MATERIAL: 18 ga. FINISH: Galvanized G60.

Heavy cast aluminum post base. May be secured to concrete with 12" anchor bolt, dowel or other type of fastener. Secure post to base with wood screws or nails. The center recess accommo- dates the fastener head or nut and washer. Weep holes provide drainage and air circulation. Sand blasted finish requires no paint. Dimensioned for 3-12" x 3-12" or 5-12" x 5-12" net size posts. MATERIAL: Aluminum FINISH: Plain

For anchoring sills to masonry walls. 2" thread one end. Oppo- site end bent 1-12" on inside. Nuts and washers included. MATERIAL: 12Ó and 38Ó Diam. round bar stock. FINISH: Mill.Anchors mudsill andor stud to slab or footer. Hammer prongs into form before pour or MS-10 can be positioned after pour. Easy to screed concrete and wrap around sill or nail to stud. Excellent 1100 lb. uplift rating. MATERIAL: 16 ga. FINISH: Galvanized