Post Buy Requirement
FC
United States
Add Review

Our Products

Vel-Max Filter Vessel

  • Height 36 in 914 mm
  • Cover Width 13 7/16 in 341 mm
  • Cover Length 11 5/8 in 295 mm
  • Dry Weight 110 lbs 50 kgs
Compact
Flexible Filtration
Multipurpose Design
Simplified Maintenance
The compact Vel-Max Filter Vessel is suitable for flowrates up to 204 USGPM with micronic cartridges, up to 198 USGPM as a filterseparator, and up to 150 USGPM with CDF monitor cartridges. The Vel-Max can be used on mobile refueling equipment, fueling cabinets and for fixed fueling installations. Vel-Max is designed for easy maintenance and easy conversion to a prefilter, filterseparator, or monitor.
Carbon steel construction
250 psi design pressure
Epoxy powder coated interior & exterior
2" NPT female inletoutlet
12 " NPT drain connection
34" NPT vent and relief connection
12" NPT sight glass connections
1" NPT water probe connection
18" NPT differential pressure gauge connections
Lid Gasket: G-2052 (Buna N)
View Complete Details

Vertical Filter

  • Filter Type Vertical
  • Flow Rate 50 gpm
  • Volume 14 gal
  • Weight 360 lbs
APIIP 1581 5th Edition Qualified VV-Series
Compact VV Series FilterSeparators comply fully with APIIP 1581, Fifth Edition, requirements for Category C equipment. Units are designed for ease of maintenance with one piece threaded base "C5" Series Coalescer Elements and reusable one-piece Teflon coated screen "V5" Series Separator Elements. Compact FilterSeparator Vessels for Fixed Installations.
150 PSI ASME Code Construction
RF Flanged Connections
Swing Bolted Closure
Buna-N O-ring Cover Seal
MIL-PRF-4556 Epoxy Coated Interior, Primer Exterior
View Complete Details

Horizontal Filter

  • Volume 85 gal
  • Cover Shape Flat
  • Flange Type Raised Face Flange
V-XXXX225 Series
Horizontal FilterSeperator Vessels for Fixed Installations at Military Facilities

Easier Cartridge Change
The horizontal filterseparator design provides more convenient access to the cartridges than the vertical design.

Effluent Cleanliness
A horizontal filterseparator must be drained to change the elements. This prevents the possibility of getting dirt in the effluent that can occur if the operator does not fully drain a vertical vessel when changing elements. The separator mounting holes on a horizontal vessel are in a vertical plane at the top of the vessel so it is nearly impossible to get dirt in the effluent when cartridges are being changed.

Tested and Approved Vessels
Velcon HV-xxxx225 Series Horizontal FilterSeparators are qualified to USAF Specification 15880. This specifi cation is similar to APIIP 1581, Fifth Edition, Category M. These vessels incorporate one piece threaded base coalescer elements for easy, reliable installation and reusable one piece Teflon coated screen separators.
View Complete Details

Series 65 Basic Control Valve

  • Flange Standard ANSI B16.42
  • Flange Class 150 lbs
  • Flange Face Flat
The OCV Basic Control Valve 65 Globe and 65 Angle is a full port engineered valve. When equipped with a variety of pilots and accessories, the valve performs a wide range of automatic fluid control, making it a specified valve in municipal water, fire protection, irrigation, industrial, petroleum and aviation fueling systems.
The 65 is dependable and hard working; with a simplicity of design that ensures minimal part wear for exceptional performance and longevity.
Self-contained, the valve operates automatically off of line pressure.
The 65 consists of three major components: body, bonnet, diaphragm assembly.
View Complete Details

Series 108 Pressure Relief Control Valve

  • Flange Standard ANSI B16.42
  • Flange Class 150 lbs
  • Flange Face Flat
  • Type Pressure Relief Control
In many liquid piping systems, it is vital that line pressure is maintained within relatively narrow limits. This is the function of the 108 Pressure Relief Back Pressure Series of the OCV control valves. Installed in the main flow line. the standard Model 108-2 acts as a back-pressure or pressure sustaining valve. In this configuration, the valve maintains a constant upstream pressure regardless of fluctuating downstream demand. When used in a bypass line, the same model will function as a relief valve, protecting the system against potentially damaging surges.
Relief: Maintains a constant inlet pressure by relieving excess high pressure.
Sustaining: Prevents pressure from dropping below a minimum.
Inlet pressure is accurate over a wide range of flow.
Inlet pressure is adjustable with a complete range of control springs.
Quick opening with controlled closing.
View Complete Details

CO-718CE Clay Canister Elements

  • Length 18 in
  • Series CO-718
  • Pressures 100 psi
  • Flow Rate 6.5 gpm
The Velcon CO-718 Series elements are intended for use in all clay treatment vessels designed for nominal 7 x 18 cartridges. The treatmentpurification medium is a special blend of low volatile materials (LVM) fullers earth compounded to provide the optimum balance between adsorptive capacity and water resistance. With their ability to prevent channeling and their high particle structure stability, the elements assure reliable performance and long life in the most exacting process applications.

For further information on clay and how to deterrmine when the clay elements should be changed see data sheets.
View Complete Details

Separator Cartridges

  • OD 3 1/16 in
  • Mounting End ID 1 15/16 in
  • Opposite End ID Blind
Separator Cartridges are employed as the second stage in filter separator vessels. Their sole function is to repel coalesced water drops produced by the first stage cartridges while allowing hydrocarbon fluids to pass through. Water drops settle into the filter separator sump and are not carried downstream. All particle filtering is done by the first stage coalescer cartridge.
Optimum 2nd stage water removal.
Choice of Teflon Coated Screen, Synthetic or Pleated Paper Media.
Field proven performance.
Largest selection of replacement elements.
TCS medium is 200 mesh stainless steel screen coated on both sides with green Teflon. The screen is lockseam folded and fastened with an internal aluminum clip.
End caps and tubes are aluminum.
Gaskets are Buna-N.
Pleated medium is silicone treated resin impregnated paper with a protective outer aluminum screen jacket.
pH range is 5 to 9.
Maximum operating temperature is 200F.
View Complete Details

ACO Aquacon Aviation Fuel Filter Cartridges

  • Length 9 3/4 in
  • Inside Diameter 1 1/32 in
  • Collapse Pressure 60 psi
Removes Water and Dirt from Jet Fuel and Avgas Outside-to-In Flow Cartridges

Patented (US Patent no. 4, 242, 206) Aquacon Filter Cartridges have a unique high-capacity inner filter media which removes all free and emulsified water from hydrocarbon fuels down to less than 5 ppm in the effluent. Absorbed water is chemically locked into this media.

When a cartridge reaches its water holding capacity, its accordion pleats swell and cause an increase in the differential pressure which signals the operator to change the cartridge.

Solid contaminants are removed by the cartridges two particulate filter media layers. The pleated accordion style design provides a large surface area for maximum dir t holding capacity. Models are offered for particulate filtration down to 12 micrometer size with 98% plus efficiency. Performance is not affected by the presence of common surface active agents.
View Complete Details

Diesel Filters

  • Diameter 6" (15.2 cm
  • DFO and Aquacon AD Cartridges: VF-61 & VF-62, VelMax Series, VF Series
For over 60 years Velcon has supplied filters for fuel conditioning for applications from 5 gpm to more than 5, 000 gpm. With the world's largest indoor fuel lab, Velcon has developed a range of high quality products to meet the most stringent diesel and biodiesel fuel market needs.

DFO Series - Micronic Filtration
High Quality Filtration for Diesel and Biodiesel Appications

Features
Reduced operating costs by removing particulates that can cause engine damage
Reliable fuel injector performance when particulate contaminants are removed to meet ISO 4406 Cleanliness Standards
Improved equipment uptime, reduces equipment failures, repairs, andor replacements
All filter component compatible with diesel and biodiesel blends
Recommended change out pressure: 25 psid (1.7 bar)
Buna-N sealing materials are standard
Maximum operating temperature 225F (107C)
View Complete Details

Small Filter Housings

  • Weight 3 lbs 15 oz
  • Material Cast aluminum head, carbon steel shell with epoxy powder coated exterior & interior
  • Cover Bolted
  • Max. Operating Pressure 150 psi
These filter housings are versatile housings designed for use with several different high performance Aquacon and other filter cartridges.

Aquacon cartridges filter out water by chemically locking it into layers of super-absorbent media. Water capacity is as much as 112 quarts, depending on the specific vessel and cartridge. These cartridges also effectively filter out dirt, rust and other particulates. (See caution, back cover.)

As an Aquacon cartridge reaches its water-holding limit, the media expands very rapidly and restricts the flow. The pressure drop will rapidly increase, signaling the need to change cartridges.

The VF-61, with ACO series cartridges installed, has become the standard for low flow rate full flow aviation fuel monitor applications.
Wide variety of applications
Free and emulsified water to less than 5 ppm
12 micron particulate removal
Provides protection against slugs of water
Pressure increase signals cartridge change
Over Pressure Protection
When exposed to a high concentration of water, the differential pressure across an absorbent cartridge (AC, ACO, AD, or ASL Series cartridges) will immediately increase. Pressure bypasses or other means to limit the inlet pressure to 75 psi (5 bar) should be installed to prevent cartridge from collapsing.
View Complete Details
Tell Us What are you looking for? Will call you back

Contact Us

  • (Filtration Corp. of America)
  • Glen Ellyn, IL 60137 map, United States
  • Share us via