Hydro Leduc N.A.

APL accumulators are designed with a high mechanical resistance forged steel body. The fluid-gas separating piston is equipped with seals adapted to the fluids to convey, the operating temperature. The APL accumulators can be fitted with a charging screw or charging valve, and are a modern solution for the needs of hydraulic circuits. LEDUC APL piston accumulators, are designed: to withstand very high volumetric ratios to ensure total and rapid discharge of fluid for assembly in any position to guarantee minimal nitrogen loss overtime for easy adaptation for use with different fluids and temperat

LEDUC spherical accumulators (AS-AC) consist of two hemispherical shells which are screwed together and which hold a diaphragm. This diaphragm has a metal stud which closes off the operation hole when the fluid is completely discharged. There is therefore no danger of damage to the diaphragm. The gas side port is fitted with a charging valve allowing the pressure in the accumulator to be checked or changed

• TXV Pump40

TXVA pumps are intelligent pumps! With variable displacement and pressure-flow control -called Load Sensing- they automatically regulate to give just what is needed for each movement. Specifically designed for the needs of the truck hydraulic market, the TXV pumps are particularly attractive solutions for applications in loading cranes, forestry cranes, refuse vehicles, salt spreaders and snow and ice equipment, and construction equipment vehicles. Extremely compact in size (only 125mm wide) to allow direct flange-mounting on engine PTOs or gearbox PTOs, TXV pumps are available in 7 models from 40cc to 150cc maximum displacement. Maximum service pressure is up to 440 bar depending on models.

• Weight14

a forged steel body, a bladder, a charging valve, an oil side orifice fitted with a poppet valve which prevents extrusion of the bladder, and an air bleed screw used during system start-up. Advantages: Bladder accumulator component parts are interchangeable with those of major accumulators available. Dimensions allow for easy installation and also use in batteries.

• Volume (L)0.7
• Weight (kg)4
• Length A (mm)175

The ACS-ACSL type welded accumulators are made up of a shell in high resistance steel containing a fluid-gas separator. This separator is made of nitrile for the standard ACS range, and of hydrogenated nitrile fo r low temperature applications. The separator is fitted with an anti-extrusion stud, thus allowing rapid and total discharge of the accumulator.