Midwest Finishing Systems, Inc.

• ModelRT-2400
• DIAMETER24", 30"

• ModelEasy-Trunk
• Dimension28.0 711.2 40.9 1038.9 38.6 980.4

• Diameter150, 250, 300, 350 or 400 mm
• sizeP100, P150, P180, P220 or P220

• pressure650

With Empire’s pneumatic blast and recovery system (PRS), you can tap the cost-saving advantages of more durable media for only a modest investment. The PRS lets you move up to recyclable media such as aluminum oxide, chilled iron and steel grit, which can be used effectively over and over—from 6 to 200 times. Conservative studies show an investment in a PRS is recouped in as few as ten weeks in terms of reduced costs for replacement media, disposal of spent media and man-hours required to move this material around. After that, years of higher profits lie ahead. The PRS relies on an exclusive cyclonic media reclaimer, which extracts good, reusable media from unwanted dust and debris. As a result, you get consistent performance from your media cycle after cycle. The PRS incorporates a SuperBlast 650 pressure system with 780 remote controls for ease of operation and maintenance. A dust collector, which captures 99% of particles one micron in size, permits conveying air to be recirculated into the workplace, thereby reducing HVAC costs. The system’s 10-horsepower blower extends effective work area and recovers media at rates exceeding 70 pounds per minutes. These units handle media sizes up to A-12 aluminum oxide and G-25 steel grit.

• size14 ft long x 7 ft wide x 8 ft

The pre-assembled blast room is built on a rigid structural steel floor, with 10-gauge steel walls and 16-gauge steel ceiling, 1-12 inch thick floor grating, and full-height, full-width work doors. High volume air inlets and a rugged down-flow dust collector combine to create true cross-draft ventilation at 50 fpm to minimize dust clouding inside. Bright fluorescent lighting enhances visibility. Place the room on any smooth, level floor and install a ramp to minimize site-prep requirements, or install in a pit to make the blast room floor level with your existing floor.

• Size3/4-inch

Cleaning and Preventing Corrosion with Proper Surface Preparation Clemco pipe tools help you get the job done faster, enhancing productivity and saving you money. Clemco tools are engineered for a wide range of pipe diameters and most common blast abrasives. Each tool handles a specified pipe diameter range with the use of centering devices. Easy Set Up and Use These pneumatic tools use compressed air, common abrasives, and standard blast machines, coupled blast hose attached to a customer-provided pipe lance normally in a length that matches the pipe to be cleaned. The tool is placed at the far end of the pipe and drawn manually through the pipe at a speed determined to clean the pipe to the desired degree of cleanliness.