Our Products
>> Hub Clamps These parts are sized to fit our split hub gears and pulleys, allowing you to repeatedly remove or adjust your part's position on a shaft. Parts are available in several styles, with reduced clearance and balancing options for demanding applications. >> Screw Type Clamp These clamps allow you to apply pressure by tightening 4 set screws spaced radially along the outside of the part. >> Set Screw Collars PIC's set screw collars are convenient for locating and retaining components on a shaft. Use the set screw to hold the collar's position, a small recess is located 90 from the screw as a start for a drill; you have the option of drilling through the collar and shaft to install a pin for the best results. >> Split Type Clamp This is a heavy duty clamp design when higher holding forces are required.
>> Brakes PIC offers a selection of flange mounted shaft brakes that can be actuated by either applying or removing voltage. Our parts come in several voltage ranges and a number of bore sizes to complement our standard shafting. >> Clutches Our catalog offers clutches that either act between two shafts or between a shaft and a mounted component like a gear or pulley. Products are available for either continuous slip or electrical engagement duty. Slip torque is pre-set and selectable on some models, while other models are fully adjustable. >> Flexible Couplings PIC has a complete line of flexible couplings that can accommodate the misalignments expected when assembling precision drives. >> Joints When shaft to shaft misalignment is great, PIC can provide either single or double universal joints in both plastic and stainless steel.