Placid Industries Inc

we offer follower arm potentiometers. MAINTAIN CONSTANT TENSION The follower arm potentiometer is used to maintain constant tension when using a brake for producing unwind (payout) tension, or when using a clutch for rewind tension.

• MOQ 1 Piece(s)
• Torque: 0.6 to 35 lb.-inchesTorque: 7 to 395 N-cm
• 12, 24 or 90 volts DCsingle or double sided solid shaft
• Hollow shaftimperial (inch) or metric mounting holes

• MOQ 1 Piece(s)
• Torque: 1.2 to 40 oz.-inchesTorque: 0.85 to 28 N-cm
• 12 or 24 voltssingle or double sided shaft

we offer magnetic particle clutches. with no electrical excitation, the input shaft & output shaft freely rotate. with electrical excitation, the output shaft becomes coupled to the input shaft. while the load torque is less than the output torque, the clutch drives without slip. when the load torque is increased, the clutch will slip smoothly at the torque level set by the coil input current.

we offer Flexible Couplings. When a brake or clutch is foot mounted, and connected to a fully supported shaft, a flexible coupling must be used. Since perfect shaft alignment is impossible, flexible couplings are needed to protect the bearings from destructive side loads.

• MOQ 1 Piece(s)
• Torque: 0.3 to 15 lb.-inchesTorque: 3.4 to 170 N-cm
• 12, 24 or 90 volts DCsingle or double sided solid shaft
• Hollow shaftImperial (inch) or metric mounting holes