PlastiFabLeed Plastics

• Part Name:Dipole
• Part Description:Cylindrical Spacer
• Tightest Tolerance:+.002
• Part Width:1.600" o.d. Dia.

This part was fabricated in conjunction with a Non-Disclosed Defense Agency with classified use. Using customer supplied material, the material sheet was CNC Saw cut to workable size. Blanks were then milled on specialized table & spot checked continuously throughout run to ensure + .002 tolerance requirements. Parts were shipped to customer for assembly then sent back for final trims & finishes of assembled part allowing a zero margin for error to customer requirement.

• Part Name:Top Cover
• Tightest Tolerance:+.002"
• Part Length:18.02"

This part was fabricated in conjunction with a Non-Disclosed Defense Agency with classified use. Using customer supplied material, the material sheet was CNC Saw cut to workable size. Blanks were then milled on specialized table & spot checked continuously throughout run to ensure + .002 tolerance requirements. Parts were shipped to customer for assembly then sent back for final trims & finishes of assembled part allowing a zero margin for error to customer requirement.

• Part Name:Housing
• Part Description:Housing
• Tightest Tolerance:+.005"

This part was fabricated in conjunction with a Non-Disclosed Space Agency with classified use. Using customer required material, the material sheet was CNC Saw cut to workable size. Blanks were then milled on specialized table & spot checked continuously throughout run to ensure + .005 tolerance requirements for multiple cylindrical cavities & holes. Special attention was needed in regard to shrinkage & load relief of part resulting in specialized placement of part while machining.

• Part Name:Block
• Tightest Tolerance:±.010"
• Part Length:4.881"

This part was fabricated in conjunction with a Non-Disclosed MilitaryAerospace Agency with classified use. Using customer required material, the material sheet was CNC Saw cut to workable size. Blanks were then milled on specialized table fixture & spot checked continuously throughout run to ensure + .010 tolerance requirements for unique circularangled cutouts & holes.

• Part Name:Switch Board
• Tightest Tolerance:±.010"
• Part Length:6.750"

This part was fabricated in conjunction with a Motion Picture Projector company. Using customer required material, the material sheet was CNC Saw cut to workable size. Blanks were then routed to tolerance requirements for unique circularovular cutouts to be used within customer built equipment. This part is made to withstand both consistent maintenance wear as well as cover & insulate against potential electrical shock.