PressureLinks

Sometimes this is referred to as the 20, 000 p.s.i. (pounds per square inch) fitting. This fitting design consists of parallel threads and an external cone. The connection seals on the cone. Stocked in 316 Stainless Steel material.

Our extensive product and manufacturing experience gives us the ability to handle all types of non-standard requests. We usually do not require prints, so if you know what you need, please give us a call. Chances are we have done it many times before.

Sometimes this is referred to as the 10, 000 p.s.i. (pounds per square inch) fitting. This fitting design consists of parallel threads and an external cone. The connection seals on the cone. Stocked in 316 Stainless Steel material.

This connection is sometimes referred to as a reverse high pressure, or a hydraulics connection. The design consists of parallel threads and an internal cone. The connection seals on the cone. Stocked in 316 Stainless Steel material.

This is a very common connection in Europe. See variations below. Stocked in 316 Stainless Steel material. There are two types of BSP connections, a BSP Taper and a BSP Parallel. The taper version is very much like the NPT fitting where the sealing surface (for pressure) is the threads. The Parallel type has several variations. First a flat face, an internal cone, and yet another with an external cone. Threads are straight threads which do not seal; the sealing surface is an o'ring, dowty seal, some other form of gasket, or on the cone if it is the cone variation. Care must be taken to get the right one.

This is a very common connection. NPT adapters are used in general plumbing, hydraulics and numerous other applications. The thread has a taper of 1 degree and 47 minutes resulting in the tightening of the male into the female port. The sealing (for pressure) surface is the threads. Stocked in 316 Stainless Steel material.