Product Components Corporation

United States

• Same patented rolled head design as washers, with varying sleeve extensions • Tightening of assembly allows cold flow of plastic into double flanged grommet • Can be used with nylon flat washer, without hole protusion • Use with metal rivets allows permanent fastener insulation • Spinning or heat forming sleeve end allows use as eyelets or grommets

• Injection molded threaded studs with chamfer on both ends are available in several of the most popular sizes and lengths • Molded in natural Nylon 66 UL 94V2. • Resistant to most chemicals, electrically insulating, non-magnetic, lightweight, low thermal conductivity, vibration and abrasion resistant • Nylon Tolerances meet I.F.I. standards

• Phillips drive available in some sizes • Nylon Tolerances meet I.F.I. standards. Screws molded in other materials may be out of tolerance • Nylon Screws can be dyed black at no additional charge OR dyed red, yellow, green and blue for a nominal charge (not a color match)

• Nylon tolerance meets I.F.I. standards • Screws molded in other materials may be out of tolerance • Nylon Screws can be dyed black for no additional charge, OR dyed red, yellow, green and blue for a nominal charge (no color match)

• Nylon tolerance meets I.F.I. standards • Screws molded in other materials may be out of tolerance • Nylon Screws can be dyed black for no additional charge, OR dyed red, yellow, green and blue for a nominal charge (no color match) • Screw lengths of 1-12" or longer may not be fully threaded • Thread Portion: 2x the diameter + 14"

• Low thermal, electrical conductivity, high strength-to-weight ratio, corrosion resistant • Useful as tie rods, U bolts, screw adjusters, bolt lengtheners • Some sizes may not be available in some materials