Puritan Magnetics, Inc.

This unit simply suspends above the conveyor belt or the head pulley and lifts tramp metal from the product burden as it passes through the powerful magnetic field. Four eyebolts are provided for suspension (suspension chain not included). Cleaning is achieved by manually removing the collected tramp metal from the face of the magnet. E-Z CLEAN options are available to simplify cleaning. Available in permanent and electromagnetic designs.

Plate Magnets are designed for use in chutes and suspension over conveyed product. Installed on the bottom side of a chute, a Plate Magnet will provide maximum protection as product travels through the powerful magnetic circuit. The magnetic field projects from the face of the Plate Magnet reaching into the product stream and pulling the ferrous contaminants to the magnet face. The magnetic field on a Plate Magnet is strongest at the surface and gets weaker the further you move away. To prevent captured ferrous contaminants from being washed off from oncoming product, a trap face design should be chosen. A trap face is a tapered step on the magnets working surface. This trap is placed at a position within the north and south magnetic fields that cause captured ferrous contaminants to be drawn to the underside of the trap where they are safely held on to, preventing washoff from oncoming product. It is also important to note that the magnetic area of a Plate Magnet should cover the entire width of the spout it is protecting.

Blank Fanners are designed to magnetically separate oily and sticky hard to separate steel sheets. This eliminates having to pry apart each sheet individually which can result in damage to the part or operator injury. This also aids in automated systems and prevents costly damage due to double blanks. Blank Fanners should be atleast 2" taller than the blank stack height.

Manual Clean Drawer Magnets provide excellent equipment and product protection of medium and fine ferrous contaminants in dry, free flowing products under gravity flow. Multiple staggered rows provide maximum contact area for product flow. As product flows through the stainless steel housing, it cascades over the staggered rows of magnetic tubes. Ferrous contaminants are pulled to the surface of the magnets where they move to the underside of the tube to prevent any washoff. Drawer Magnets should be cleaned periodically for the most efficient performance. To clean the magnetic tubes, release the latch assembly and open the door. Remove the grate assemblies one at a time. Remove the tramp metal by hand. Use extreme caution and wear gloves during the process. Rare earth magnets are extremely powerful and tramp metal is very difficult to remove by hand. EZ CLEAN™ or POW-R CLEAN™ options should be considered.

Power supplies provide quick cycling required for automated equipment Standard round, square, and rectangular sizes available Power supplies with various contrMixed demolition debris Crushed or broken concrete Mixed solids at MRF facilities Processing of shredded tires Scrap yards Slag and coal operations Recycling Facilities Automated parts transfer Temporary holding and fixturing ol options

Engineered to remove fine to large ferrous contaminants from high volume, gravity fed product streams. Puritan’s Vertical Spout Magnets are ideally suited for products that would bridge or choke in a magnetic tube type separator. Ferrous contaminants are easily removed from products that are moist, lumpy, granular, or in powder form. Vertical Spout Magnets consist of a housing and two opposing Plate Magnets. A center diverter on the housing inlet helps direct product towards the magnets. Ferrous contaminants are pulled from the flowing product and are captured by the powerful magnets. A Single Trap face design eliminates the possibility of the captured tramp metal being washed off back into the product stream.