Other Products / Services

Installs into thin, harder, high strength steel materials (high strength steel sheets at 975MPA maximum ultimate tensile)
Allows overall weight reduction for all vehicles
Provides lower installed cost
Unplated threads may be oversized sized as permitted by thread standards to accept minimum plating thickness of 0.000200.0051 mm
Compare to other thin sheet fastening devices:
Addresses environmental concerns
Smaller outer diameter
Lighter weight
Flush on reverse side of panel
Close to edge of panel

Type RAA right angle fasteners for sheet metal can accept thread forming or self-tapping screws.Type RAA right angle fasteners for sheet metal can accept thread forming or self-tapping screws.Type RAA right angle fasteners for sheet metal can accept thread forming or self-tapping screws.

The thread locking torque performance of Type PL and PLC PEMHEX self-clinching fasteners is equivalent to applicable NASM25027 specifications. A nylon hexagonal element provides a reusable, non-metallic prevailing torque thread lock. The strong knurled collar receives the installation force and resists torque. The spin resistance of the knurl greatly exceeds the torque that can be exerted by the self-locking feature. As the knurled collar is embedded in the sheet, the undercut cavity beneath

FLOATING NUTS, LOCKING THREADS These fasteners provide load-bearing threads in thin sheets and permit up to 0.76 mm adjustment for mating hole misalignment.

The self-clinching feature offers fast and simple assembly. The fasteners are squeezed into prepared holes using any standard press. The sheet remains flush on one side, and the fastener is permanently locked in place.

Extra strength and support in assembly is obtained by the threads of the floating nut extending fully into the retainer shank

PEMSERT SELF fasteners are ideal for flush applications where a stainless steel sheet requires loadbearing threads. The PEM flush nut can be installed easily by squeezing it into a round hole in metal sheets. When the fastener is properly installed, both the top and the bottom of the sheet remain flat, enhancing the functional and cosmetic qualities of the entire assembly. The hexagonal head along with the proven PEM

Meets torque requirements for IFI 100107 Grade B (unified) and ANSI B18.16.1M (metric) locknuts.
Type H is for use in sheet hardness HRB 80 or less on the Rockwell "B" scale.
Type HNL are for use in sheet hardness HRB 60 or less on the Rockwell "B" scale