Our Products #4972945

Heavy gauge steel brackets to hold together the four corners of the table apron and provide a means of fastening the leg to the bracket. A hanger screw is driven into the leg and locked into, place through the bracket with a wing nut. Zinc Plated.

Tan polyethylene pins with glue-retainer ribs. Will not shrink, swell or rust. Smooth, self-lubricating.

Unique mechanism hiding a 28" counter-top extension inside the cabinet, ready to be extracted for additional eating or work surface. The extension is solidly held without any added supports or braces.
Cabinet interior depth: 520mm (20-12")
Pullout table: One 500mm (19-1116") board with two hinged additions of 150mm (5-1516") each.

Package Consist of: One pair of mechanisms (left & right), two guide rails, 6 rollers with accessories, installation instructions.

Each pair holds 16 cassettes in upright position for quick accessibility.
1516" high x 12-12" long x 1-12" wide for 16 unit

Each pair holds 10 cassettes in upright position with labels in view and ready to be extracted.
1516" high x 12-12" long x 1-12" wide for 10 units

Mount a shelf to the wall (up to 2" thick!) and how it was hung no one can tell! Screw anchors are placed in the wall in 6mm (1564") holes and the mounting bracket is affixed to them. The support rod is fixed to the mounting bracket with set screws (vertically and horizontally adjustable). Holes (12mm diam. x 3-58" deep) are drilled into the rear of the shelf to seat the rod. For super-invisibility, a 78" wide groove by 316" deep may be cut into the shelf back for full concealment.
Load Rating: 2 units-90 lbs., 3 units-135 lbs.
Packed in bags each containing one unit: 1 mounting bracket, 1 support rod, 6 screws and 6 plastic screw anchors (100 per box)

mounting on cabinet ceiling or behind shelf for back reflection with two screws through steel bracket. UL-CSA approved, supplied with 7-feet of cord, molded , 2-prong plug and 25-watt standard Edison base lamp. Reflector is baked brown walnut on steel exterior.
8-14" long x 1-34" high. Rugged construction

The most popular and easiest-to-use system to provide for storage of compact discs. Produced in grained black break-resistant ABS Nylon, these are fixed to the drawer or shelf surface with self-adhesive pads already installed or with screws. Each piece has two self-adhesive pads and two countersunk screw holes for #6 flat head screws.

After you have drilled the proper size hole, attach the 2 spring clips to the sides of the fixtures. Insert the fixture into the hole with the long arms upright inside the opening. The shorter arms will be underneath the shell.
Gently slide the fixture upwards. Place paper between the shell and the short arms of the spring clip to protect the finish.
When the fixture is fully inserted, the long arm will snap down over the top to secure the fixture.

Crystal clear polyethylene with a bearing surface of 38"x38" to lend a sparkle underneath the glass shelf. Steel-pin is molded in for security. Pin is 5mm. diameter x 8mm long and can be inserted from both sides of a 58" partition.