Our Products #4949383

Complete Pendant Push Button StationsEach station includes the switches listed plus a legend plate sheet, Neoprene cord grip, strain relief attachment and Neoprene boots.Be sure to specify cable diameter when ordering stations. Up to Five Motions plus AccessoriesPre-Wired Stations Available from FactoryBright Yellow Finish for Easy VisibilityCompact Design Available in Xyron EnclosuresTwo-Piece Enclosure Simplifies Field WiringDouble-Break Silver-Plated Switch ContactsNeon Pilot Light for Cool Trouble-Free OperationEasy-to-Read Button Name PlatesNEP7IA1, 3, 4, 4x, and 12ULCSA Approved (UL: E45587; CSA: LR-24077) Wide Temperature Range: -10F to +150FReplaceable Neoprene BootsRubber Bushing and Water-Resistant Packing

Heat Shrinkable Cable Connectors for Single Cable and Multiple Cable Groupings Corrosion ResistantFlame RetardantExceed Navy Requirements for Tightness and Integrity when used with One Flat Cable or Multiple Flat Cables of the Same Size.

To order, add the suffix "X" to the catalog number of the desired trolley. Also available with stainless steel and brass wheels.For number required refer to Installation and Technical Data Bulletin and Festoon Price List.

Duct-O-Wire Figure 8 Conductor Bars are furnished as assemblies consisting of a ten-foot long conductor bar rated at 600 volts, an insulating cover, splice cover, and connector pins or joint clamps as applicable.The insulating cover must be appropriate for the environment indoor, outdoor, or high temperature in which the conductor is to operate.Indoor systems are for use in ambient temperatures up to 160F. They have an Orange PVC Insulating Cover. They are not recommended for outdoor use in direct sunlight.Outdoor systems are for use in direct sunlight and ambient temperatures up to 160F. They have a Gray PVC Insulating Cover with an ultraviolet additive.High temperature systems are for use in ambient temperatures up to 280F. They have a Yellow Lexan lnsulating Cover.From the table to the right, you can select the basic (FE) conductor assembly with the appropriate bar and insulating cover for your application.

P-Sehes Collectors are used on straight and curved runs and transfers. The pantograph design provides virtually constant spring pressure for the entire stroke range. Lateral Mount Collectors are provided with spring balance. Conductor Bars must be spaced at least 3 inches apart. To order bronze collectors with stainless steel hardware, add "BR" to the catalog number. Call factory for prices.

These hangers are not recommended for curves, switches or short runs unless separate anchors are used.

Each assembly consists of a ten-foot conductor bar, insulating cover, connector pins for one end, guide assembly, two power feeds with a jumper cable and hanger set.

C-Series Collectors are used on short continuous run systems. They feature steel pivot points for good tracking capability.

One required for each mounting bracket for each track run, except for FC-T1CHF.Two clamps and hardware to secure track to angle mounting bracket.

One required for each track system.Steel bar, 18" long, with flat plate for mounting on moving equipment. Includes standard saddle which can be placed at desired position along length of bar.