Stinar Corporation

350 gallon (1325 L) waste, 200 (757 L) gallon flushrinse tank capacity -Stainless steel tanks with baffles -Stainless steel waste hose drain pan -Waste tank sight window -Galvaneal shroud -Open dump -Flush waterrinse tank level gauge -Flush waterrinse tank flow meter -Low-level cut-off switch located in the flush waterrinse tank -Spring loaded hose reel for flush rinsewater hose, 25 ft. of 1-inch (25.4mm) hose -Underside of lavatory service module undercoated -Rear platform grip strut decking -Back-up alarm -Amber flashing beacon -Work lights located in pump compartment and on rear shroud -Protected by epoxy-based primer and two coats of polyurethane paint -Instructional placards -If shipped via ocean freight or during the winter season, an application of water- based corrosion inhibitor is applied -One (1) combined Stinar Operation, Parts and Maintenance manual

Approximate exterior van body dimensions: L-216”, H-96”, W-96” (5486mm x 2438mm x 2438mm) -Approximate interior van body dimensions: L-210”, H-89”, W-91” (5334mm x 2261mm x 2311mm) -Payload capacity: 5000 lbs. (2270 kg.) -Maximum front platform height –228” (5791 mm) -Exterior van body walls constructed with white painted aluminum -Interior van body walls constructed with ¼” glass board lining -Aluminum diamond plate non-skid floor -All interior seams caulked for moisture protection -Storage cabinet with shelves located along interior passenger side wall -54” (1372 mm) long x 26” (660 mm) deep cleaning cart stall -120” (3048 mm) long Passenger bench seat -Rear deck 96” (2439 mm) wide x 48” (1219 mm) deep -Aluminum diamond plate floor -Access steps with handrail to platform deck -Screen guard panels are removable for loading purposes on three sides -Two floodlights installed on both the front and rear exterior of van body illuminates the front platform and rear deck -Six surface mount lights illuminate the van body interior Available Options: -Heavy Duty wrap-around bumper and grill guard -Two-way extending platform -Full width Swivel bumper -Four-way extending platform -Platform bumper tape contact switch -Emergency 12V electrichydraulic power pack -Fold-up van body shelf -Translucent van body roof -Van body heater

Services aircraft doorsill heights of 101 to 228 inches (2565 to 5791 mm) -Approximate exterior van body dimensions: L-240”, W-96”, H-96” (6096 mm x 2438 mm x 2438 mm) -Approximate interior van body dimensions: L-232”, W-92”, H-90” (5893 mm x 2337 mm x 2286 mm) -Exterior van body walls constructed with white painted aluminum -Interior van body walls constructed with 14” glass board -Two 15, 000 BTU Air conditionersheaters with diesel engine driven generator -Insulated ceiling and walls -12 VDC powered roof vent fan -Two windows per side -Front and rear sliding doors -Powered lift gate raises wheelchairsstretchers from ground level -Two attendant’s seats -Configured for six wheelchairs, two stretchers with three wheelchairs, or four stretchers with no wheelchairs -Luggage storage cabinet -Intercom system between van body and driver’s cab -Six interior van body lights -Two floodlights at the front and rear of the van body to illuminate work areas -Protected by epoxy-based primer and two coats of polyurethane paint Available Options: -Heavy Duty wrap-around bumper and grill guard -Platform bumper tape switch -Emergency 12V electrichydraulic power pack

70 gallon (265 L) waste tank, 40 gallon (151 L) flushrinse tank capacity -Stainless steel tanks -Hand pump -Tie down rings -U.S. Property ID tag

Designed to PD07WRGBGBEC41specification -6, 000 lb. van body payload capacity -1, 000 lb. over cab platform payload capacity -Maximum over cab platform height – 324” -Lowered over cab platform height – 119” -Lowered van body floor height – 71” -Front and rear roll-up doors -Single axle chassis -Protected with epoxy based primer and polyurethane paint Available Options: -Heavy duty Type A Winterization -Two additional cargo transfer lights -Driver and passenger side spotlights -Manual tailgate -Hydraulic tailgate