Band Heaters in USA

• Temperature : 800°F

A mica core produces a thin, efficient heater. Heat from the precisely wound element is quickly transferred to the working surface for expedited heat up. Mica provides optimum dielectric strength and heat transfer capabilities for an extended heater life. The mica core is encased in a corrosion resistant shea more...

• BUILT-IN : Same features as the independent strap. The top sheet is made into a strap by placing barrel nut fasteners on either side of the gap. Barrel nuts are used for holes and cutouts, as an alternative to independent straps
• WEDGE LOCK : Basic design for limited space above the heater. Composed of clamp slides (wedge shape) on the lips of the heater on either side of the gap. Standard height between the inner diameter and the highest point of the wedge lock is 5/16”
• INDEPENDENT STRAP : Straps are tightly clamped around the cylinder's surface and distribute the drawing force uniformly around the band heater. This force is transferred to the inside windings and improves heat transfer by providing effective surface contact and elimina
• FLANGE LOCK-UP : The most economical clamping mechanism. Designed for narrow heaters.
• SPOT-WELDED : Design is similar to that of the built-in barrel nut. Made of an independent strap fastener that is spot welded to the top sheet on each side of the gap. This type of clamping mechanism is used to accommodate a heated section below the fastener.

Tanks requiring industrial tank heaters can utilize indirect heating with band heaters or, they can use direct heating that typically uses some form of immersion heating. Indirect Heating WATTCO Band heaters can be found in several types of dimension, wattage, voltages and material. Mica band heaters are an i more...

Mi-PlusTM is a mineral insulated band heater designed for applications that require high watt density andor high operating temperatures. Mi-Plus band heater has a thin low profile cross section using all stainless steel sheath material. The clamping brackets are formed from the outer sheath of the band heater more...

New XT Performance – The next generation of excellence in Heater performance and quality. The XT band provides for higher temperature performance, complete design flexibility and improves energy efficiency all at a lower cost than Mineral Insulated heaters. Typical Applications: • Injection Molding – Au more...

The Hotwatt Standard Band Heaters are manufactured in one or two piece constructions with maximum inside diameters of 11 12" and 22 12" respectively. Three or more sections are employed when heaters of larger diameters are needed (as for blown film extrusion dies). Holes and cutouts are available. Maximum wat more...

Nozzle band heaters by Thermal Corp; HotNoz™, last more than seventeen times longer than the best competitor units tested and can operate at over ninety watts per square inch. more...

The MI band heater from Watlow® is a high-performance heater. Its performance and name are derived from Watlow’s exclusive mineral insulation - a material with much higher thermal conductivity than mica and hard ceramic insulators used in conventional heaters. A thin layer of the “high” thermal conduct more...

Tutco offers a variety of band heaters to accommodate any cylindrical application. Tutco's product offering ranges from the HT Mica Band using high temperature mica and sheath materials for your high temperature applications, to the better belly band used for compressor applications. more...

Band heaters are computer designed and manufactured to your specifications. Only the highest quality materials are used for optimal performance. Our stock band heater inventory is constantly growing. We stock a wide variety of heaters right on the shelf that are available for same day shipping. Band heaters a more...