Our Products

Each complete LOCKERBASKET is furnished with 9-0 of Moore MCO-100 Machine Link Chain and a Locking Plate and swivel sub assembly. This housing assembly is connected to the Moore Polycore cable and is used to raise and lower the LOCKERBASKET. The wide-profiled surface of the chain provides for a comfortable, secure handgrip for operating LOCKERBASKETS. A Locking Bolt is designed to fit through the Locking Plate when the basket has been raised and secured in place with a padlock.

Each complete LOCKERBASKET is furnished with 9-0 of Moore MCO-100 Machine Link Chain and a Locking Plate and swivel sub assembly. This housing assembly is connected to the Moore Polycore cable and is used to raise and lower the LOCKERBASKET. The wide-profiled surface of the chain provides for a comfortable, secure handgrip for operating LOCKERBASKETS. When the basket has been raised the locking plate fits over the Anchor Hook and is secured in place with a padlock.

The Descent Control Device (DCD) enhances the safety and reliability of the LOCKERBASKET System by automatically arresting a falling basket in the event the operator loses control of the hoisting chain or a malfunction in the equipment occurs. It is easily installed in new or existing changerooms. It comes with a factory attached steel coupler designed to assist in the proper installation and prevent unintentional removal after installation. The dual braking system minimizes ratcheting that occurs in some descent control devices through dissipation of energy in the secondary friction brake system after the primary brake has been activated. The locking mechanism will not activate when the basket is ssafely lowered. Should the locking mechanism engage, it will remain locked until the tension on the device is relieved by the operator. The DCD is also calibrated to allow an empty basket ot be lowered to proper operating heights.

MOORFRAME is a high strength (50, 000 psi yield point), cold rolled galvanized steel channel that is prepunched for easy installation of pulleys and locking assembly. MOORFRAME is designed to support the Moore LOCKERBASKET System overhead on clear spans up to 10-0. This flexibility makes it possible to be used equally well in steel, concrete or wooden structures; and in both flat roof and rigid frame design. MOORFRAME engineering and framing attachment details are completely covered in our installation instructions.

Moore standard operating equipment is shipped complete with 16-0 (not pre-cut) of Moore Polycore cable per LOCKERASKET for operating over pulleys. The 18 Moore cable is manufactured from high quality preformed galvanized steel wire, stranded around a polycore fiber. This unique construction absorbs the high concentration of internal stresses which are formed by the LOCKERBASKET hoisting action. The cable is designed for 280 pounds working load limit (maximum break strength of 1, 400 pounds) and is shipped with cable fittings.

The Cushion Spring Assembly is designed to absorb 125 foot pounds and comes complete with connecting links. Two spring links are required per cushion spring, and they are fabricated from annealed spring wire, which is hardened, tempered and galvanized after fabrication. The Cushion Spring Assembly also includes a vinyl spring cover.

Fabricated from heavy extruded striated aluminum, in satin anodized finish, ALUMIBENCH is 9-12 wide x 1-34 deep with integral reinforcing ribs. It is designed to span 6-0 between supports with carry capacity of 200 pounds per lineal foot. Furnished in standard 12-0 lengths. Complete with aluminum caps for ends of bench rows, sections may be joined at pedestals to give long continuous runs. The ALUMIBENCH provides warm, comfortable changeroom seating.

Two (2) Moore double swivel eye cable groove pulleys are supplied per LOCKERBASKET MS-614 or MS-610. The Moore pulley is designed with a 4-38 sheave, injection molded from the dimensionally stable and self-lubricating Delrin plastic. The sheave is designed to properly cradle the polycore cable to give it a silent, smooth action. The housing is fabricated from 16-gauge stainless steel with a light chrome finish. The double swivel eye prevents the pulley from binding regardless of the roof pitch or direction the MOORFRAME runs.