Traffic Safety System LLC

Traffic Safety System LLC

Fairview, United States

Pump Boss 200

Pump Boss 200

We are the leading manufacturers, exporters and suppliers of Pump Boss 200 from Alabama, US. PumpBoss 200 pressure governor is built using the state-of-the-art programmable microprocessor technology. It operates in two distinct modes such as pressure or RPM. You can maintain a steady pump discharge by way of controlling the engine speed or holding a selected engine RPM. The 200 model is capable of regulating the pump pressure on the basis of discharge pressure only.  The common application of this governor can be found in fire service. It comes with a 4-digit LED display that displays four LED bar graphs that displays a constant display of transmission temperature, engine coolant temperature, battery voltage and oil pressure engine. There is also a message display that will notify during normal operations as well as fault warnings. The pressure mode maintains a constant pump discharge pressure. You can compare and monitor this pressure via selected pressure setting. The RPM mode aids in maintaining a constant engine RPM. You can see a minor increase in the pump discharge pressure of 30 PSI. In case the discharge is higher than 30 PSI, the governor will lower the RPM engine to reduce the discharge pressure. There is a large control knob that is easy to operate using a gloved hand. The salient features include programmable preset settings, no pressure or rpm variation when changing modes, interlock signal recognition with throttle ready LED, j1939 can bus for engine information and control, single 300 psi discharge pressure sensor, KPa / bar (optional), retains warning alerts history, always starts in pressure mode at idle RPM, recognition of no water condition with automatic response, diagnostic capabilities, limits increase of pressure when in rpm mode, high idle input for external switch, manual control of pressure or engine rpm settings, displays and LEDs automatically adjusted for day or night operation, audible alarm buzzer (optional) and red idle button - brings the engine to idle rpm quickly


How does it work?

  • In pressure mode the governor maintains a constant pump discharge pressure. The discharge pressure is monitored and compared to the selected pressure setting, the engine RPM is varied to keep the discharge pressure at the selected setting.  
  • In RPM mode the governor maintains a constant engine RPM. The pump discharge pressure is monitored, it can vary but is limited to an increase of 30 PSI. If the discharge pressure increases 30 PSI, the pressure governor automatically lowers the engine RPM to reduce the discharge pressure.

Looking for Pump Boss 200?

[+] View All Products


Contact Details

Mr. Joe Robbinson

PO Box 116, Fairview, - 28730, United States

View Mobile No.