Tri-State Overhead Crane

• ModelAG-1-7/10-10
• Capacity1 Ton
• Height Under Boom (HUB)7 to 10 ft. (adjustable)
• I-Beam Depth6 in.
• I-Beam Flange Width3.332 in.

• Voltage230 VAC (3-phase)
• Max. Motor FLA1.6 Amps (confirm actual motor full load amps)
• Motor HP1/4 (HP is for reference only and should not be used to size drive)

• Part No.REFLX120

The ReFlx 120 prevents crane-to-crane or crane-to-end-stop collisions and is most commonly used in applications requiring only a stop command. The two-channels in the sensor will be used as a primary stop and an emergency redundant stop. The system features a reliable, solid-state control board in a small, easy-to-install enclosure. This system is intended for use with overhead crane bridges and trolleys, and monorails, to prevent collisions or to limit the approach of adjacent bridges, trolleys, monorails or structures. Ideal for a primary stop and an emergency redundant stop action 20-120 foot detection range* (*Runway length may be greater than detection range) IP67 rating for indoor applications only (This system may not operate properly in direct sunlight or inclement weather conditions) 120 or 240 VAC Ability to be removed from its enclosure and mounted on an existing control panel

• Capacity1/2 Ton (1000 lbs.)
• Height Under Boom (HUB)6 to 9 ft. (adjustable)
• Span8 ft.
• I-Beam Size5" X 3.284" X 0.494"
• I-Beam Flange Width3.284 in.

• Transmitter Weights156g / 5.5oz (with batteries installed)
• Receiver Weights1.0kg / 2.2lb (includes output cable)
• Transmitting Power1mW
• Transmitter Operating Voltage3.0VDC

• Capacity300 lbs.
• Weight26 lbs.
• Voltage115-1-60 VAC
• Pendant Drop LengthStandard - 4 ft. less than lift
• Motor HP1/16