Williamson New England Electric Motor Service Corp.

• Model Number42-0007
• Horsepower:1/6, 1/4, 1/2 HP
• Volts:115 V
• Hertz60 Hz
• Cord Length9 ft

Use fully or partially submerged Durable polypropylene housing High quality sealed motor Thermal overload protected motor Model 42 is adaptable for use with standard garden hose (fitting included), 1” NPT pipe, or 1 ¼” slip fit (use discharge hose kit PN 1010-0117) Screened bottom may be removed to allow easy cleaning Use indoors or outdoors Models 42 and 44 oil free Models 42 and 44 remove water from any flat surface down to 18”; model 46 will pump down to 1”. Lightweight and portable Compact design: Models 42 and 44 will fit in a 7” opening One year limited warranty Temperature rating 104°F (40°C) Non-automatic 42, 44 and 46 models

• Model Number507-0005 M53

Application- for clear water, emergency backup usage when power is off or the primary pump(s) fail Extra protection when the primary AC pump fails due to power outages in storms, brownouts, wiring or electrical problems, when the primary pump fails due to damage, mechanical malfunction or obstructions in the pit, or when the primary pump fails to keep up with excessive water due to rain or overloading No other system offers the reliability and protection provided by the Basement Sentry® Series. Zoeller’s time tested design experience gives you the needed performance and reliability

• Model No.M267

Float operated, submersible (NEMA 6) 2-pole mechanical switch. Durable cast construction. ASTM Class 25 Cast iron, switch case, and pump housing. Cast iron base on 267, 268. Non-Clogging Vortex Impeller Design. Engineered plastic impeller with metal inserts. Not affected by materials normally found in drainage and sewage sumps. Stainless steel screws, bolts, handle, guard, and arm and seal assembly. UL Listed 3-wire neoprene cord and plug. 10 ft. cord . Square Ring & Gasket - Neoprene. Motor - 12HP, 115 VOLTS, 10.4AMPS, 60 Hz, 1725 RPM, oil-filled, hermetically sealed, automatic reset thermal overload protected. Oil lubricated bearings. Carbon and ceramic shaft seal.

• FL AMPS:23
• BEARING-DRIVE-END6206
• DESIGN CODEL

5HP, 1725RPM, 1PH, 60HZ, 184T, 3640LC, OPEN, F1 Manufacturer: Baldor Manufacturer Part No: L1410T FREE STANDARD UPS SHIPPING FOR LOWER 48 STATESFL AMPS:

• Model Number#004702

ZOELLER SWITCH KIT #004702 , FITS M53 AND M57 PUMPS. THIS KIT INCLUDES EVERY THING YOU NEED TO CHANGE THE SWITCH. MOST IMPORTANT YOU SHOULD CHANGE THE ARM AND SEAL WHEN YOU CHANGE THE SWITCH BECAUSE THE RUBBER BOOT GETS STIFF AND SOMETIMES WILL MAKE THE SWITCH STICK.