PVC, PP & Plastic Products #4931364

Fluoro-Plastics compression molds rods and cylinders for machining in a wide range of sizes. The most common sizes are listed in the table below, but many other combinations of OD and ID are available. Molded rods are preferred for machining because compression molding yields greater material homogeneity for the finished part.

Molded plate is available in thicknesses from 38ths of an inch up to four inches. Plate is inventoried in sizes from one-foot square to four feet square (sixteen square feet per sheet). Thickness tolerances range from plus .038" to minus .019" for 38th plate, up to plus .087", minus .043" for one-inch plate. Fluoro-Plastics will build special size molds for production quantities of non-standard dimensional plate. Unless otherwise specified, the edges are not trimmed and all plate is oversized so that blanks can be cut without significant kerf waste. All material is white. Plate is ideal for cutting into bIanks for machining into smaller parts. All material conforms to ASTM D3294 and MIL-P22241.

Rod is available in both virgin grades and reprocessed (mechanical) for less demanding applications. Surf Technologies extrudes rod in all standard sizes from 18th inch diameter up to 4 inches in diameter. Rod is inventoried in twelve foot lengths so it can be cut into six foot lengths (UPS shipping) or less, as ordered. PTFE rod is generally used as machining stock for all kinds of chemical, electrical and mechanical components where the outstanding performance characteristics of PTFE are required. Various fillers are available to modify the properties of PTFE to meet application requirements. Fluoro-Plastics stocks huge inventories so that same day shipment of most standard sizes is available. Conforms to ASTM D 1710 and MIL-P 19468.

Molded plate is available in thicknesses from 38ths of an inch up to four inches. Plate is inventoried in sizes from one-foot square to four feet square (sixteen square feet per sheet). Thickness tolerances range from plus .038" to minus .019" for 38th plate, up to plus .087", minus .043" for one-inch plate. Fluoro-Plastics will build special size molds for production quantities of non-standard dimensional plate. Unless otherwise specified, the edges are not trimmed and all plate is oversized so that blanks can be cut without significant kerf waste. All material is white. Plate is ideal for cutting into bIanks for machining into smaller parts. All material conforms to ASTM D3294 and MIL-P22241.