Sherborne Sensors, Inc.

United States

The LSO is a high precision gravity referenced servo inclinometer that can be used for a wide variety of industrial and military applications. Models are available in a variety of angular ranges each with low impedance output signals. Electrical terminations are via 6-way bayonet lock connector (LSOC) or solder pins (LSOP). It is extremely robust and will withstand shocks in excess of 1500g. The design is well proven with many thousands in use throughout the world in the most demanding of applications.

The T133 Series is a small, cost-effective, single or dual axis inclinometer. It is available with 0-10V, 4-20mA or RS232 outputs and can be operated from an unregulated voltage source of between 10 and 30 volts dc.

The T2335 Series is a range of dual axis gravity referenced servo inclinometers that can be used for a wide variety of industrial and military applications where high precision angular measurements are required in rugged and robust applications where high levels of vibration and mechanical shock up to 1500g are encountered. Models are available in a variety of ranges from +-1 degree to +-90 degrees with low impedance output voltage signals and are precisely set up for dual axis operation. Electrical terminations are via a connector on the T233 or solder pins on the T235 variant.

The DSIC Series is a range of single and dual axis gravity referenced digital output servo inclinometers with total error band of less than 0.08 degrees over -20C to +70C. They are suitable for use in a wide variety of industrial and military applications where high precision angular measurements are required in rugged and robust applications where high levels of vibration and mechanical shock up to 1250g may be encountered. Models are available in a variety of angular ranges from +-5 to +-60 with RS485 ASCII outputs and electrical terminations are via a connector.

The T435 L series is a family of single axis, high-precision, closed loop, gravity referenced servo inclinometers, ideal for use within a variety of application environments, and where space is at a premium. Available in ranges from 3 to 90 with a form factor measuring only 61mm (2.41 inches) high and a diameter measuring less than 37mm (1.46 inches). The T435 L has a high-level 4-20mA signal, proportional to the sine of the angle of tilt. Units are fully self-contained, and able to connect to a DC power source and readout or control device, to form a complete operating system. Units are extremely rugged, and can withstand a 1500g-shock event. Solder pin terminations are standard. The 4-20mA output of the T435 L series is specifically designed for electrically noisy environments, or where inclinometer output signals must travel over a long distance. T435 L series inclinometers operate on a single 24Vdc supply and the output series load resistance can be as high as 400. Sherborne Sensors T435 L series inclinometers have a long and successful market history in precision tilt applications around the world.

The DSIC Series is a range of single and dual axis gravity referenced digital output servo inclinometers with total error band of less than 0.08 degrees over -20C to +70C. They are suitable for use in a wide variety of industrial and military applications where high precision angular measurements are required in rugged and robust applications where high levels of vibration and mechanical shock up to 1250g may be encountered. Models are available in a variety of angular ranges from +-5 to +-60 with RS485 ASCII outputs and electrical terminations are via a connector.