Hot Melts are 100% non-volatile thermoplastic materials, solid at room temperature, melted to the application temperature desired, and applied in the molten state. A bond formation is obtained by cooling the substance to solidify after the wetting and penetration of both surfaces. Packaging and converting grade products are based on EVA. Hot Melts are formulated to provide desired adhesion, speed of set, open timebonding range, and heat andor cold resistance properties. Use of the highest quality raw materials with formulation compatibility yield excellent thermal stability and consistency of application and performance. Advantages Fast set speeds - high through putAdhesion to difficult or non-porous surfaces, wax coatings, poly-laminated stocks, plastics, etc.Water resistant Excellent glue line control No special storage conditionsGap filling (100% solids)Limitations Temperature sensitivity Special equipment requirements -- correct settingsadjustments is critical to performanceLow penetrationLimited toughness