Many Strainsert Instrumented Load Pin designs are incorporated into sheave and pulley systems. The user has the option of either designing a sheave around our standard CPA Clevis Pin series or having a custom pin manufactured for an existing sheave design with a tailored measurement capacity and geometry, allowing for simple installation and optimized measurement capacity. The Instrumented Sheave Pins are often used to measure line tension by monitoring reaction load on the pin. Using the equations provided below, the line tension can be determined.Strainsert factory calibrations are intended to simulate installed conditions, however, it is recommended that an in-place calibration be performed to account for any installation, tolerance, andor alignment influences affecting sensor measurement.