Air Operated Diverter Valves provide much improved operator safety by allowing control of flow and pressure to be carried out remotely. When air is sent to the cylinder, the valve closes and allows the system to build pressure. The valve opens when the air is exhausted, reducing more...
The design and construction of this valve is similar to an airlock in that the housing, closed end single blade diverting rotor and end plates are machined to tight tolerances. End plates, seals and bearings are protected from the material flow by the diverter rotor hubs and, in more...
Working pressure: : max. 2.0 bar, min. -0.3 bar (29 / -4.3 PSI)
Diameter : 50 ~ 200 mm (2 ~ 8 in)
The VAB Flap Diverter Valve uses a swinging flap to divert material from one duct to another. VAB Flap Diverter Valves are fitted on pneumatic conveying ducts in which switching the flow of material to different production lines is required.more...
The APR R1 Diverter Valve is a critical performance upgrade recommended at all stages of performance as it replaces the failure prone factory unit. The R1 is designed withstand extreme boost pressures at the highest levels of performance, while offering lightning fast response thmore...
Pneuveyor manufactures a full range of flap, knife gate, scaling and multi-port diverter valves. Flap type used for diversion of non-abrasive materials from one destination to another. Knife gate type with wear protectors used for abrasive andor vacuum service. Multi-port valves more...