Pumps, Pumping Machines & Parts #6697905

hap horizontal heavy duty slurry pump

main specifications

size: 1-18 inches

capacity: 10-9000 m3/h

head: 5-120m

material: hi-chromium metal liner, or rubber liner

seal: packing seal, expeller seal and mechanical seal

LAP Low Abrisive Slurry Pump

Main Specifications

Size: 1-30 inches

Capacity: 25-13860 m3/h

Head: 5-60m

Material: Hi-chromium metal liner, or Rubber liner

Seal: Packing seal, Expeller seal

hhd high head duty slurry pump

main specifications

size: 1-6 inches

capacity: 0-1000 m3/h

head: 0-100m

material: hi-chromium alloy metal liner

seal: packing seal, expeller seal

vsp series vertical sump slurry pump

main specifications

productvsp series

diameter: 40mm-300mm

flow: 17m3/h-1267m3/h

head: 4m-40m

material: hi-chrome alloy metal liner or rubber liner

pump features

1.the zgb(p) pumps are horizontal single-stage , single-suction , cantilever , double-casing , centrifugal slurry pump .this series pumps are large capacity, high head and multi-stage. The wet parts of zgb and zgbp pump at the same outlet diameter can be interchangeable. Their outline installation dimensions are one and the same.

2.the drive part of this series slurry pump: horizontal split frame with oil lubrication and two sets of water cooling systems inside and outside has been adopted.

3.the pumps are wide passage , non-clogging and good performance of npsh. The pumps expeller seal combined with packing seal and mechanical seal have be adopted to guarantee the slurry from leakage

wn dredging pump

dredging pump is a horizontal centrifugal pump, specially produced for the river, lake and sea dredging. With the advantage of light weight, good wear resistance, strong suction ability, max flow particle size and so on.

the pump system is mainly composed of dredging pump head, dredging pump gearbox, high-elastic coupling, marine transmission monitoring system.

the wet pump parts of impeller, front liner, rear liner is made of special high chrome alloy, with the hardness not less than 58hrc, while the pump casing material selection, takes into account the pressure requirements, to use of wear-resistant cast steel, with a hardness about 48hrc. And also depending on the different dredging application, we use different material to meet the requirements of the customer.

pump type of 200wn to500wn, the pump shaft seal could use mechanical seal, soft packing seal or mechanical seal plus soft packing seal.

pump type of 600wn to 1000wn, the pump shaft seal is a spiral sleeve l-shaped rubber sealing.