Minimize the Over-SprayMinimize the Cleanup in the Work Area Minimize Airborne Droplets of Fluids in the Air Minimize Labor by Automating Dispensing of Fluids Minimize the Amount of Fluids Used to Manufacture a Part Minimize the Cleanup of Parts after Manufacturing is CompletedThe MinaMizer is aptly named because it minimizes the amount of air and fluid used in fine spray applications. It is common sense to use equipment sophisticated enough to dispense the least amount of fluid necessary to accomplish the right amount of coverage for a particular application. Using excess fluid accomplishes nothing except increasing material cost, part cleanup cost and machine cleanup cost. The MinaMizer uses precision air and fluid regulators that hold true to their settings to maintain the fluid and air pressures being dispensed out the nozzles. Precision Needle valves control the volume of fluid being dispensed out of the nozzle. A variety of controls, both manual and computer controlled are offered to allow for individual preferences in setting up an installation. The design of the MinaMizer Nozzle allows for an even, consistent, low pressure, low volume spray pattern. When the MinaMizer is activated a low pressure air assist allows the fluid to be dispensed in a light coating from a single or multiple nozzles. The low pressure breaks the fluid to be dispensed in a light coating from a single or multiple nozzles. All the nozzles, ( up to six) work in unison to cover large or small areas with an even coating. Nozzles can dispense fluid continuously or in an OnOff mode as directed by a LSP Electronic Controller.