SERIES : 2302, Poly-Toggle™ Plastic Hollow Wall Anchors
Drill Diameter : 5/16 in
The Poly Toggle™ is a screw actuated hollow wall anchor for use in paneling, wallboard and solid masonry available in 6 sizes to match the most common wall thicknesses. In solid base materials, the anchor can be used by removing the outer wings. The performance of this product more...
Red Head Tapcon ¼” Stainless Steel Hex Head Anchor is the "original masonry" anchor that cuts its own threads into concrete, brick, or block. Maximum performance is achieved because the Tapcon Anchor, the Condrive Installation Tool, and the carbide-tipped Tapcon Drill Bits aremore...
This Spike impact pin anchor by Powers Fasteners features a pre-expanded anchor design that allows for easy installation. In addition, the Tie Wire version is an easy to install alternative to direct fastening (e.g. powder actuated). The Spike is a, one-piece, vibration resistantmore...
Ultra Tech Industries carries a full line of anchors including many heavy duty and industrial use concrete anchors to meet most concrete anchoring needs. Available in a wide range of sizes, anchors are available in; hot-dip galvanized, zinc plated, 304 stainless steel and 316 stamore...
Ribbed Conical Plastic Anchor ia a light duty plastic anchor uses sheet metal screws and is best in drywall and plaster. The ribbed design helps prevent spinning and the anchor is designed to expand and hold to a greater degree than a standard conical anchor. Each size can use a more...
Nylon Anchors FeaturesBenefits: Can be used in concrete, block, brick and sheetrock Integral unit made of nylon with steel nail 3 head style - round, flat or mushroom Removeable nail more...
Wedge anchors are installed in pre-drilled holes and are supplied with a nut and washer. The anchor is inserted through the mating material and into the drilled hole until the anchor threads are below the concrete surface. The nut is tightened with a wrench wedging the clip portimore...
A fastener consisting of a cylindrical expander shell with longitudinal sections of its shank removed. This design allows the shell to be pulled toward the head and form anchoring legs on the blind side of the assembly. The shell has a tapered, sharp point at one end and a flangemore...