QUICKHAMMER® SDS PLUS DRILL BITS For drilling in concrete, brick, stone, marble, tile, plaster, and other masonry materials For use in SDS plus hammer drills only more...
SDS-Plus® Carbide Drill Bits are designed for use in a rotary hammer equipped with an SDS (slotted drive shaft) type chuck. The bits are manufactured to conform with ANSI Standard B212.15 and can be used to drill in concrete, block, brick, and soft stone. As existing stock of the single tip SDS Plus Carbide more...
When the drill point penetrates enough for the second margin to contact the wall of the hole, the point is stabilized and true cylindrical geometry is established. Smooth accurate holes are produced and reaming can often be eliminated. more...
ToolShed 14mm 12" Reduced Shank Drill Bit Designed to increase the drilling capacity of drill chucks and for large scale boring. Made from high grade M2 high speed steel, these drill bits have a precision ground flute for a better quality cut and longer life. 118 deg. point, suitable for common general purpos more...
Get Quotes from Verified Suppliers
Submicron carbide grade and Tail coating provides maximum wear resistance when cutting high carbon, high alloy and stainless steels, titanium, high temperature alloys, aluminum, bronze, cast and ductile iron. Jobber length and 140° double split point eliminate spot drilling and reaming in most instances. Hea more...
Jobber Length Drills - Letter Sizes, Black Oxide Finish, High Speed Steel - Allegiance, Made In USA Allegiance Jobber Length Drills are ground from the solid, have a 118 Deg point and designed for general purpose drilling in various materials such as cast iron and steel. They are commonly used in production o more...
Specially designed and manufactured to use in our 2" Pneumatic Rotary Hammer Drills and our 2" Hydraulic Rotary Hammer Drills. These carbide-tipped hammer drill bits will provide maximum performance and extended life providing a lower cost per job. more...
Fractional General Purpose Jobber Length Drills - 118° Point, Straight Shank - High Speed Steel Bright Finish with polished flutes enhances chip ejection especially for aluminum and other non-ferrous materials. more...
High Speed Steel 118-Degree Point, Fully Ground From Solid Use for High Production Black-Surface Treated These drills are recommended for ferrous metals (steel iron). They have a surface treatment that reduces the amount of chip welding. Bright-Polished Flute These drills can be used in a wide range of materi more...
Twist Drill 2 helical flutes 4 guide edges High feed rates Excellent chip evacuation Deep hole drilling more...
Connect with us
