Adhesive & Non-Adhesive Tapes #4936878

Impregnated fiberglass cloth, consisting of warp and fill yarns, and coated with a high temperature silicone adhesive. Also offered in acrylic adhesive. Excellent electrical, mechanical and chemical properties. This tape is used as a primary insulation in a variety of electrical equipment and heat sealing bars, chute liners, gaskets, bearing surfaces, tabletop covers, guide rails and roll covers. Low friction surface, abrasion resistance.

Impregnated fiberglass cloth, consisting of warp and fill yarns, and coated with a high temperature silicone adhesive. Excellent electrical, mechanical and chemical properties. Used as a primary insulation in a variety of electrical equipment and heat sealing bars, chute liners, gaskets, bearing surfaces, tabletop covers, guide rails and roll covers. Low friction surface; abrasion resistant. Product comes standard with liner. Self-wound is optional at no additional cost (specify no liner by adding SW to product number, e.g. TFE-6SW). 12 AND 34 WIDE ROLLS MUST BE SELF WOUND. Operating temperature range: -100F to +500F (-73C to +260C). 3 plastic core.

Pure skived PTFE with a high temp. Silicone adhesive. Used in electrical applications such as harnesscoil wraps & separators, transformers and slot liners where good insulation and heat resistance are required. Also used in mechanical applications such as heat sealing bars & jaws, labeling machine pressure pads, chute liners, anti-friction devices, bearings, forming dies, aircraft mold release & guide rails where high temperature, maximum slip and lubricity are required. High elongation permits tight wrapping; conforms to sharp bendsirregular surfaces. *TFES-2HD is a high density, TENSILIZED skived PTFE film which provides higher tensile strength, lower elongation and higher dielectric strength than regular skived film (primarily used for electrical applications listed above & for roll protection in flat die extrusion) and meets spec AA-59474 Type-1, Superseding 23594C Type 1. 3 plastic core

2.7 mil (0.068mm). 40 micron film. A biaxially oriented polypropylene tape, coated with a solvent based acrylic adhesive.Adhesion: 30 ozin. Tensile: 24 lbsin. Elongation at break: 140%.Temp. resistance: 32F to 140F. Meets Spec A-A-1684C See-through CRYSTAL CLEAR imprinted on 3 core. Crystal clear tape is non-yellowing & UV resistant with long shelf life and no fish eyes. Used for moderate demand lamination and carton sealing applications. May also be used in cold temperature applications.Alternative to Achem #12W Available widths ranging from 38" to 49" width Comes in 55 and 110 Yd Length

DC-2315. Crepe Paper with Crepe Liner6.0 mil (10.4 mil with liner). 4.3 mil crepe paper coated on bothsides with an aggressive natural rubberresin adhesive &wound with a white crepe paper liner. Good quick stick; greatadhesive strength; bonds to most surfaces. Used in the printingindustry, textile manufacturing (twistingspinning process), steelrule die-makersdie-cutters (make-ready), & carpet installation.For bonding, mounting, holding, joining, core start-ups, andsplicing applications. Used for repairingreplacing golf club grips.Adhesion: 47 ozin. Quick Stick: 20 ozin. Tensile: 23 lbsin.Elongation: 8.5%. 3 neutral corecarton.48 (1219mm) x 720YD Jumbos Available. Alternative to IPG #592; Shurtape #GG 200; #DF 63.