Physiotherapy Products & Equipment #5222918

Rated capacities of basket hitches are based on minimum diameterof curvature at the point of load contact of 10 times therope diameter.**Rated capacities of choker hitches apply when the angleof choke is greater than 120.

The emergence of the Inspectable RoundSling has eliminated the need for costly or confusing accessories to perform visual inspections. Traditional opaque roundslings have become unnecessary, impractical, costly, and above all else less safe.

Never use a sling without training.Always inform yourselfAsk your employer for the manufacturers sling use limitations.Always comply with applicable Federal and local regulations.Always know load weight.Never use a sling without a legible rated load tag.Never overload a sling.Never ride on sling or load.Never use an improper sling configuration.Never use a worn-out or damaged sling.Never use a sling in extreme temperatures.Never use a sling in acidic conditions.Never use a sling without training. OSHA regulation requires responsible work practice. The employee shall permit only those employees qualified by training or experience to operate equipment or machinery- OSHA 1926.20 (a) (4). Employee training should include information given in OSHA training literature, ASME B30.10a 1996 Hooks safety standards and this document. Always inform yourself. Ask your employer for chain sling safe use information. The employer shall instruct each employee in the recognition and avoidance of unsafe conditions and the regulations applicable to his work environment to control or eliminate any hazards or other exposure to injury OSHA 1926.21 (b) (2).

Black Diamond Cordura 700 One Stripe Medium Duty Web Eye & Eye Slings1lack Diamond Cordura 1200 Two StripesThe Strongest Abrasion-Resistant Sling

M chain inspection programsCM provides chain users with a wide range of informative materials and instructive programs on chain and chain inspection. Our colorful chain safety posterchart and our fact-filled booklet, CM Lifting, Pulling & Binding Products Manual PMC-10, are available on request. Cm chain seminars on proper chain use, care and inspection are conducted at our headquarters in Amherst, New York, and in plants across the country. Video cassette training programs, slide and film presentations and in-plant chain sling inspections are also available. CM education programs are designed to promote the proper use of all CM products, and to assist users in complying with OSHA regulations.

Rated capacity in tons of 2, 000 lbs. Rated capacities shown apply only to 619 and 636 classification wire rope.Rated capacities basket hitch based on Dd ratio of 25. Rated capacities based on pin diameter no larger than natural eye width or less than the nominal sling diameter. Rated capacities based on design factor of 5. Horizontal sling angles less than 30 degrees shall not be used.

Dimensions(inches)DameterMaterialAInsidewidthBInsidelengthCTypeDOS5 ft. reach(in.)(mm)6045307325.53, 6003, 0002, 100HA4013321123893276, 1004, 9003, 500HA501221259381012, 30010, 0007, 100HA753423451218121320, 80017, 00012, 000HA1001312731581631, 30025, 60018, 100HA12511443883449342049, 00040, 00028, 300HA150112514101271782259, 20048, 40034, 200HA1751346129812682, 60067, 40047, 700HA200271413211432125, 200102, 20072, 300HA225214816221

Type 1 is a general-purpose sling, which is adaptable for basket, and straightpull hitches.This type of sling is used more widely than any other for generalmaterials handling.Extra Improved Plow Steel Refer to ANSI B30.9 for full detailsRated capacity basket hitch based on Dd ratio of 25 times the rope diameter. Rated capacity based on pin diameter no larger thannatural eye width or less than the nominal sling diameter. Rated capacity based on design factor of 5. Horizontal sling angles less than30 degrees shall not be used. Fittings must be specified when ordering slings. Check fittings section for other fittings that may be usedwith these slings.

Length ToleranceHand spliced slings are manufactured to a length tolerance of plus or minus 2 rope diameters or plus or minus 0.5% of sling length, whichever is greater. Slings, which will be used as matched sets will be within 12 rope diameter of each other.

VI Return eye (reversed eye) sling is formed by usingmultiple widths of webbing held edge to edge. A wear pad isattached on both sides of the sling body and on both sidesof the loop eyes to form a loop eye at each end which is ata right angle to the plane of the sling body.

3 and 4 Type III Sling made with a flat loop eye on eachend with loop eye opening on same plane as sling body.This type of sling is sometimes called a flat eye andeye, eye and eye, double eye sling.

BodyWidthCodeNumberVerticalBasketHitch Cap. in Lbs.EyeLengthEyeWidth6WLA1-9063, 0001016WLA2-9066, 0001018WLA1-9083, 0001018WLA2-9086, 00010110WLA1-9103, 00012110WLA2-9106, 00012112WLA1-9123, 00012112WLA2-9126, 00012116WLA1-9165, 00012216WLA2-91610, 00012220WLA1-9205, 00018220WLA2-92010, 00018224WLA1-9245, 00018224WLA2-92410, 000182

3 & 4 Slings 3" Wide and Over have Tapered Eyes. Nylon Slings Furnished Yellow Treated. Polyester Slings Furnished Gray Treated with "Monster Edge". *Add"PME" to Stock No. for Polyester "Monster Edge" PME is available in 1, 2, 3, 4 & 6" widths 9800 SeriesGray Treated with "Monster Edge"

Bail-TypeMagnet Chain AssembliesAnalloy casting supplied with welded links and chain.Magnet not included with assembly

Note: 332 316 utilize galvanized small cord minimum breaking force. Rated capacities basket hitch and vertical lift based on Dd ratio of 25.Where d = the rope component diameter.Rated capacities based on design factor of 5.Rated capacities based on pin diameter no smaller than 5 times the body diameter and no larger than the natural width of the eye.Horizontal sling angles less than 30 degrees shall not be used.

Adjustable all-purpose utility slingLifts evenuneven loads easilyLightweight and portableSaves timeAvailable in 6 and 10 reachHook latch optional

Rated capacity Basket Hicth based on Dd ratio of 25 times the component rope diameter. Rated capacity based on pin diameter no larger than natural eye width or less than the nominal sling diameter. Rated capacity based on design factor of 5 *Mechanical Splice ***Work Load Limit Horizontal sling angles less than 30 degrees shall not be used.Larger sizes are available upon request.