A new and revolutionary product from the designers at Wilco in coordination with global leader in filtration technology, Donaldson Torit. This dust collector is a pressure vessel designed to ASME section VIII, rated for full vacuum and maximum working pressure of 40-PSI. Inside the tank, four Donaldson PowerCore filters are mounted in secure Donaldson retention brackets. These state-of-the-art filters provide for an impressive yet conservative flow rating of 900-SCFM while maintaining a MERV 13 filter efficiency rating per ASHRAE 52.2-2007. Filters are cleaned via a reverse pulsejet design, positioned optimally for efficient cleaning of the filters. The cleaning is controlled using a custom controller with a standard periodic cleaning cycle, and with a operator initiated manual cleaning cycle either from the plant control room or from a button on the controller box. Filters are easily changed in minutes with no tools required. Filter replacement cost is roughly one-quarter of that for a conventional bag filter of similar capacity. The tank is a drop-in replacement for the Wilco 19- and 31-bag dust collectors for minimal installation down-time. This is a direct fit for Wilco 400- and 700-CUFT scale and blend tanks, but custom tank mountings can be arranged. Collector requires 10-SCFM of 90 to 100-PSI clean, dry, compressed air for cleaning and 110V for controls. Tank comes equipped with 5 main and 3 choke vents, pressure gauge port, and 3 vacuum port, 20 Wilco designed manway, filters, cleaning assembly, and cleaning control box.