Power Converter #5216443

The RailQor line Series DC-DC converters is designed to provide isolated dc power in the transportation industry for such electronics as LED displays, audio amplifiers, safety monitors, lighting, and communications systems under the European Standard EN 50155. These converters use SynQor's synchronous rectifier based technology to achieve extremely effiicient industry leading performance. Due to the difficult environmental conditions the transportation market poses on power supplies, SynQor has designed the RailQor line for optimal performance in the most demanding applications.

The BusQor bus converter are the next-generation, board-mountable, isolated, fixed switching frequency DC-DC converters that use synchronous rectification to achieve extremely high conversion efficiency. The BusQor bus converters are available in Un-regulated, Semi-regulated, Fully-regulated and High Input Voltage models. The SynQor bus converters are ideal for creating the mid-bus voltage required to drive standard point-of-load (non-isolated) DC-DC isolated converters.

The CFQor series of Quarter-Brick DC-DC converters are high efficiency converters designed for those medical applications that require isolation and leakage current levels that comply with IEC60601-1 for CF patient contact and are also defibrillation proof.

Single and dual output DC-DC converter are composed of next-generation, board-mountable, isolated, fixed switching frequency DC-DC converters that use synchronous rectification to achieve extremely high power conversion efficiency. The power dissipated by the converter is so low that a heatsink is not required, which saves cost, weight, height, and application effort. All of the power and control components are mounted to the multi-layer PCB substrate.

The NiQor DC-DC converter is a non-isolated buck regulator, which employs synchronous rectification to achieve extremely high conversion efficiency. The NiQor family of converters are used predominately in DPA systems using a front end DC-DC high power brick (48Vin to low voltage bus). The non-isolated NiQor converters are then used at the point of load to create the low voltage outputs required by the design. The wide trim module can be programmed to a variety of output voltages through the use of a single external resistor.

The InQor Series is composed of next-generation, board-mountable, isolated, fixed switching frequency DCDC converters that use synchronous rectification to achieve extremely high power conversion efficiency. Each module is supplied completely encased to provide protection from harsh environments.